• Stainless steel distributor - manifold Kit D1”x 3/4” and Eurocon outputs with fully equipped flowmeters
• they are made of high-quality stainless-steel type AISI 304
• adjustment on each circuit using flow meters
• possibility of mounting the thermoelectric actuator for the automation of the installation
• number of ways: 2 - 12
• equipped with fill/drain valves, automatic air vents and valve

Connecting the circuits to the distributor - manifold kit

• Install at 40 - 90 cm above the ground.
• Fit the isolation valves to the ends of the distributor - manifold kit bars
• Loosen the return valve cover to open all circuits to be used
• Remove the plastic cover of the flowmeters
• Fully open the flowmeter
• Loosen the connection between the pipes and the manifolds
• Secure the nut, the brass ring and end part of the eurocon connector
• Tighten the connection between the connector and the manifolds

Filling the manifolds with water

• Fill the distributor and the hydraulic system with water using the filling valve
• Fill the distributor and the hydraulic system with water using the filling valve
• Check the tightness of the circuits, close the isolation valves and increase the pressure to 6 bar and hold it for 24 hours using the test pump by means of the filling/drain valve.
• If the pressure remains the same after 24 hours, lower the pressure to 1-1,5 bar using the drain valve.
• Adjust the flow rate for each circuit according to the design flow rate, by checking the guide line of the flowmeter
• If the pressure drops, check all connections and all circuits.